What are the operating procedures for car lift?

1、 Before use, remove the tools and sundries that hinder the operation near the lift, and check whether the operating handle is normal.

2、 The operating mechanism is sensitive and effective, and the hydraulic system is not allowed to creep.

3、 When supporting the vehicle, the four supporting angles shall be on the same plane, and the height of the supporting angle rubber pad shall be adjusted to make it contact with the supporting part of the vehicle chassis.

4、 When supporting the vehicle, the vehicle shall not be too high, and the four brackets shall be locked after supporting.

5、 After the vehicle is lifted and driven in, adjust and move the lift support block to align with the specified lifting point of the vehicle.

6、 When lifting, the personnel should leave the vehicle. When lifting to the required height, the safety lock pin must be inserted and ensure safety and reliability before starting the underbody operation.

7、 Except for the minimum maintenance and minor repair items, other cumbersome and heavy operations shall not be operated and repaired on the hoist.

8、 The lifter shall not rise and fall frequently.

9、 Lift the vehicle stably and lower it slowly.

10、 It is forbidden to lift the hoist when someone is working.

11、 If it is found that the operating mechanism is not flexible, the motor is not synchronized, the bracket is uneven or the hydraulic part leaks oil, it should be reported for repair in time, and it is not allowed to operate with defects.

12、 After the operation, the sundries shall be removed and the area around the lift shall be cleaned to keep the site clean.

13、 Regularly (half a year) drain the accumulated water in the lift cylinder and check the oil quantity. If the oil quantity is insufficient, fill the pressure oil of the same brand in time. At the same time, check the lubrication, hoist transmission gear and seam