|
Inspection after starting of automobile girder calibrator1. Listen to whether the working sound of the car beam calibrator is normal and whether there is any abnormal noise. Carry out the first-level maintenance on the basis of the driver's routine maintenance. Before the first level maintenance operation, the car should be washed clean, and the engine and chassis should be free of oil and dirt after wiping. 2. Check the working condition of each instrument, lubricating water pump, distributor, steering rod ball pin, clutch pedal bracket pin, rotating shaft, front and rear leaf spring pin, door and other lubricating parts (lubricate according to the lubricating points specified in the operation manual of each vehicle). 3. Test the operation of horn sound, light, turn signal and wiper, and complete the oil nozzle of each lubricating point. 4. Check whether the brake system and steering system work normally and firmly. According to the mileage of the vehicle, different levels of maintenance work items are called level maintenance. 5. Check the fuel supply system, lubrication system, braking system, gearbox and other refrigeration systems for oil leakage and water leakage, and check and tighten the front and rear plate spring U-bolts, transmission, transmission shaft, main reducer and half shaft connecting bolts. |
